Both space and plumbing connections are tight in many basement setups. In such a situation, it is possible for the washer and washing sink to generally share the drain that is same. To be able to connect a sink up towards the drain inlet, a plumbing work fixture known as a tee will have to be installed in case it isn’t inside already. This enables the drainpipe for the sink to get in touch to your standpipe for the automatic washer.
Install Sewer Tee
Examine the sewer pipe inlet located nearest the washing and sink machine. Normally, this is a free-standing pipeline having a available end. If you have not really a connection that is tee the sink inlet, one will have to be set up.
Turn the water supply off for the automatic washer therefore the sink. These two fixtures could have two split supply valves, one for the hot and another for chilled water. Rotate the knobs regarding the ends of this valves clockwise all the best way to cut the water off.
Unplug the washer through the energy socket.
Slice the sewer inlet pipeline by 50 percent about halfway down. On steel pipe, utilize a rotary cutting device with a steel blade that is cutting. Use a hacksaw or any other saw on PVC pipe. Sand down any rough edges on the pipes.
Link a tee suitable to your sewer pipeline. Secure a metal tee into the pipeline with a plastic hose and coupling clamps. Tighten the clamps by having a screwdriver. Aim the tee in direction of the sink drainpipe. A PVC pipeline is glued into spot with primer and PVC glue.
Link a right drainpipe piece towards the the top of tee. Safe it having a rubber coupling on steel glue or pipe another PVC pipe set up. Safe the pipeline towards the nearest stud or wall surface having a clamp to help keep it steady.
Link the Sink and Automatic Washer
Insert the drain hose through the automatic washer in to the the top of sewer pipeline. Safe it set up having a synthetic tie or hose clamp.
Fit together the and put them into position between your tailpiece additionally the sewer pipeline. This can help you figure out if the pipelines should be cut further before final placement. Cut PVC pipes with a hacksaw and metal pipelines with a rotary device with a steel attachment that is cutting. Sand down any edges that are rough.
Connect the drainpipe for the sink to the tee inlet. Glue PVC pipe in spot with primer and glue. Protected steel pipeline by making use of pipe thread compound to your drainpipe before screwing it to the tee.
Insert the p-trap set up involving the tailpiece in the underside regarding the sink together with drainpipe. Slip the couplings on the final end connections and tighten up these with a wrench.
Switch on the water supply valves for the washing and sink machine by rotating them counterclockwise.
Plug the washer back in the wall socket.